When the functions of the V2 are not enough, try the V2 PLUS with programmable switches to set your custom temperatures and materials!
Currently out of stock
The XYZAP2+ offers mobility (battery powered) and flexibility in a completely new design package. This resetter beside resetting to 240m, has 3 switches at the front to select temperatures and material (ABS or PLA). It comes pre-programmed ready to use with the most useful temperature settings but you can easily change these settings using any compatible FTDI breakout board (also sold on this website). This unit uses the new chrome plated battery clips design for easy and long lasting battery replacement (The included battery lasts a very long time!).
It ships with the following pre-set temperatures:
Connect a standard FTDI programmer board at the bottom of the resetter and you can reprogram the 2 primary temperature switches (extruder temp and heated bed temp). You can set them to just about any temperature your firmware supports. For example, you may want to experiment with NinjaFlex which requires a 50*C bed temperature or try the new PET filaments which require slightly higher extruder temperatures.
Upon connecting the FTDI board, you can use the Arduino Terminal or the Terminal program in our Download section set to 115200 baud. When the connection is established the XYZAP v2+ will present the following screen:
Select option 1,2,3,4,5 to change its settings
(switch 3 is used to select ABS/OFF or PLA/ON)
Current Switch settings: ON OFF ABS
Extruder 225*C, Heated Bed 90*C, Optimized for ABS
1 - Extruder Temperature when switch 1 is OFF: 210
2 - Extruder Temperature when switch 1 is ON : 225
3 - Bed Temperature when switch 2 is OFF : 90
4 - Bed Temperature when switch 2 is ON : 110
5 - Filament length will reset to : 240m
Simply select option 1-4 and press ENTER. Type the appropriate temperature value for the desired switch settings and you're ready to go! Your temperature settings are saved in real-time in the unit's non-volatile memory until. Set the switches to your desired temperature requirements, connect it to your cartridge and push the programming button. Your cartridge will be reset to its full length and to the selected temperatures at the same time!
If the question you have has not yet been answered here, use the form below to ask something about this product.